Source:list Subsystem - R&S SMB100A Operating Manual

®
R&S SMB100A
Example:
Manual operation:
[:SOURce]:LFOutput:SIMPedance <SImpedance>
Selects the output impedance of the LF generator. Selection "LOW" and "600 Ohm"
are available.
Note: The installed hardware determines the available settings. Use the
Config
For information on the required hardware revision, refer to the release notes.
Parameters:
<SImpedance>
Example:
Manual operation:
[:SOURce]:LFOutput:VOLTage <Voltage>
Sets the voltage of the LF output signal.
Parameters:
<Voltage>
Example:
Manual operation:

7.13.7 SOURce:LIST Subsystem

This subsystem contains the commands for the List mode of the instrument.
The following settings are required to operate the instrument in List mode:
1. Create a list.
If a list which does not exist is selected with the :LIST:SEL command, an empty
list with the name of the selected list is created.
SOURce1:LIST:SEL "New_list"
Operating Manual 1407.0806.32 ─ 21
LFO:SHAP SQU
selects a rectangular shape for the signal of the LF generator.
See "LF Gen Shape"
dialog to check the hardware the instrument is equipped with.
LOW | G600
*RST:
SOUR:LFO:SIMP G600
'sets the output impedance of the LF generator to 600 Ohms
See "LF Source Impedance"
float
Range:
Increment: see the data sheet: resolution of output voltage set-
*RST:
LFO:VOLT 2 V
sets the voltage of the LF output to 2 V.
See "LF Output Voltage"
Remote Control Commands
on page 201
LOW
on page 220
see the data sheet: Internal modulation generator >
Output voltage range
ting
1
on page 219
SOURce Subsystem
Hardware
358