Web Control - R&S SMB100A Operating Manual

Rf and microwave signal generator

Hide thumbs Also See for SMB100A:

Table of Contents

To initiate a ping from the instrument to the device:

1. Enable "ICMP Ping" on the "Advanced LAN Configuration" page.

2. Select the "Ping Client" page.

3. In the "Destination Address" field, enter the IP address of the device you want to

ping (without the ping command and without any further parameters), e.g.

10.113.1.203.

4. Select "Submit".

Web Control

The web control functionality provides remote operation via VNC using a Web browser

(with HTML5). This mode does not require additional installation or activation. The

VNC protocol allows simultaneous operation from several remote devices. The instru-

ment remains locally operable.

The GUI of the R&S SMB is visible. To perform the settings, you can operate the

instrument as with the manual control. The instrument controls are available via the

front panel simulation. File upload and download between the instrument and the

remote PC is also available.

Operating Manual 1407.0806.32 ─ 21

Preparing for Use

LXI Configuration

Table of Contents