Output<Hw>:Amode; Output<Hw>:Filter:auto; Output<Hw>:Filter[:Lpass]:State - R&S SMB100A Operating Manual

®
R&S SMB100A
:OUTPut<hw>:AMODe <AMode>
Selects the mode of the attenuator at the RF output (Attenuator MODe).
Parameters:
<AMode>
Example:
Manual operation:
:OUTPut<hw>:FILTer:AUTO <Auto>
Activates automatic switching of the low harmonic filter.
Parameters:
<Auto>
Example:
Manual operation:
:OUTPut<hw>:FILTer[:LPASs]:STATe <State>
Switches the filter state in manual mode and disables the automatic mode, if activated.
Parameters:
<State>
Example:
Manual operation:
Operating Manual 1407.0806.32 ─ 21
AUTO | FIXed
AUTO
The attenuator is switched automatically. The level settings are
made in the full range.
FIXed
The level settings are made without switching the attenuator.
When this operating mode is switched on, the attenuator is fixed
in its current position and the resulting variation range is defined.
*RST: AUTO
POW:ALC ON
activates automatic level control for RF output.
OUTP:AMOD FIX
sets the fixed mode with uninterrupted level for RF output.
See "Attenuator Mode"
0 | 1 | ON | OFF
*RST: 0
OUTP:FILT:AUTO 1
Activates the auto mode.
See "Mode" on page 149
0 | 1 | OFF | ON
*RST: 0
OUTP:FILT:AUTO 0
OUTP:FILT:LPAS:STAT 1
Selects manual mode and activates the low harmonic filter.
OUTP:FILT:STAT?
Queries the current filter activity.
See "State" on page 149
Remote Control Commands
OUTPut Subsystem
on page 149
313