R&S SMB100A Operating Manual page 333

®
R&S SMB100A
Note: For power sensor with attenuator this command is automatically set to ON.
Parameters:
<State>
Example:
Manual operation:
:SENSe<ch>[:POWer]:DISPlay:PERManent:STATe <State>
The command switches on and off the permanent indication of the power measure-
ment result in the upper right corner of the block diagram. For each sensor, the type of
sensor, the connector, the measurement source and - if set - the offset is indicated.
Parameters:
<State>
Example:
Manual operation:
:SENSe<ch>[:POWer]:DISPlay:PERManent:PRIority <Priority>
The command selects which power measurement result (average or peak power) is
indicated when permanent display is active.
Parameters:
<Priority>
Example:
Manual operation:
:SENSe<ch>[:POWer]:FILTer:LENGth:AUTO?
The command queries the current filter length for auto filter mode
(:SENSe<[1]...3>:POWer:FILTer:TYPE AUTO)
Return values:
<Auto>
Operating Manual 1407.0806.32 ─ 21
0 | 1 | OFF | ON
*RST: OFF
SENS:POW:CORR:SPD:STAT ON
activates the use of the s-parameters correction data of power
sensor 1.
See "Use SParameter - Power Sensors"
0 | 1 | OFF | ON
*RST: ON
SENS1:POW:DISP:PERM:STAT ON
the permanent viewer is switched on.
See "Permanent Display State"
AVERage | PEAK
*RST: PEAK
SENS1:DISP:PERM:STAT ON
the permanent viewer is switched on.
SENS1:DISP:PERM:PRI AVER
the measured average power is indicated.
See "Display Priority" on page 170
float
Range: 1 to 65536
Remote Control Commands
SENSe, READ and INITiate Subsystems
on page 157
on page 170
318