Sense, Read And Initiate Subsystems; Output<Hw>[:State]:Pon - R&S SMB100A Operating Manual

®
R&S SMB100A
Parameters:
<State>
Example:
Manual operation:
:OUTPut<hw>[:STATe]:PON <Pon>
Selects the state of the RF output when the instrument is switched on.
Parameters:
<Pon>
Example:
Manual operation:

7.12 SENSe, READ and INITiate Subsystems

The SENSe subsystem contains the commands for configuring the power measure-
ments with R&S NRP-Zxx power sensor(s) connected to the generator. The measure-
ment is started and the measurement result retrieved with the READ command. The
description of this commands is included in the following.
Up to four sensors can be connected to the signal generator. They are distinguished by
means of the suffix under SENSe, that means SENSe [1] ... SENSe 4.
:SENSe<ch>[:POWer]:APERture:DEFault:STATe
:SENSe<ch>[:POWer]:APERture:TIMe
:INITiate<ch>[:POWer]:CONTinuous
:READ<ch>[:POWer]?
:SENSe<ch>[:POWer]:CORRection:SPDevice:STATe
:SENSe<ch>[:POWer]:DISPlay:PERManent:STATe
:SENSe<ch>[:POWer]:DISPlay:PERManent:PRIority
:SENSe<ch>[:POWer]:FILTer:LENGth:AUTO?
:SENSe<ch>[:POWer]:FILTer:LENGth[:USER]
:SENSe<ch>[:POWer]:FILTer:NSRatio
:SENSe<ch>[:POWer]:FILTer:NSRatio:MTIMe
Operating Manual 1407.0806.32 ─ 21
0 | 1 | OFF | ON
*RST: 0
OUTP OFF
deactivates the RF output.
See "RF On" on page 135
OFF | UNCHanged
OFF
deactivates the output when the instrument is switched on (RF
OFF).
UNCHanged
restores the initial state of the RF output before the last turn off.
sets the output status as it was when the instrument was
switched off.
*RST: UNCHanged
OUTP:PON OFF
RF output A is deactivated when the instrument is switched on.
See "Power-On State - RF Signal"
.............................................................................316
................................................................................316
.................................................................................................... 317
..................................................................318
..................................................................319
.............................................................................319
..................................................................320
Remote Control Commands
SENSe, READ and INITiate Subsystems
on page 151
............................................................. 316
....................................................... 317
.......................................................... 318
.........................................................318
315