R&S SMB100A Operating Manual page 484

®
R&S SMB100A
Example:
STEReo:DIRect "PIL=<State>"
STEReo:DIRect? "PIL"
(for documentation reasons only)
Activates/deactivates the pilot tone.
Use the SCPI command
Setting parameters:
<State>
Example:
Example:
STEReo:DIRect "PIL-DEV=<Deviation>"
STEReo:DIRect? "PIL-DEV"
(for documentation reasons only)
Sets the pilot tone frequency deviation (max. deviation).
Use the SCPI command
Setting parameters:
<Deviation>
Example:
Example:
STEReo:DIRect "PIL-PH=<Phase>"
STEReo:DIRect? "PIL-PH"
(for documentation reasons only)
Sets the pilot tone phase.
Use the SCPI command
Operating Manual 1407.0806.32 ─ 21
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
STEReo:DIRect? "PI"
Response: "1234"
[:SOURce]:STEReo:PILot:STATe
0 | 1
STEReo:DIRect "PIL=1"
The pilot tone is activated.
STEReo:DIRect? "PIL"
Response: "1"
[:SOURce]:STEReo:PILot[:DEViation]
Note: A four-digit value must always be set. Leading zeros, if
any, must also be specified.
Range: 0000 to 1000 (ASCII coded decimal numbers),
corresponding to 0 Hz to 10 kHz
STEReo:DIRect "PIL-DEV=1000"
Sets the frequency deviation of the pilot tone to 10 kHz.
STEReo:DIRect? "PIL-DEV"
Response: "1000"
[:SOURce]:STEReo:PILot:PHASe
Remote Control Commands
instead.
instead.
instead.
469