Source:lfoutput Subsystem - R&S SMB100A Operating Manual

®
R&S SMB100A
Parameters:
<Impedance>
Example:
Manual operation:
[:SOURce<hw>]:INPut:MODext:WIGNore <SuppressState>
Ignores warnings concerning an overload of the modulation signal input.
This setting is not affected by an instrument preset *rst or the and Save/Recall func-
tion. Only the factory preset resets this setting.
Parameters:
<SuppressState>
Example:
Manual operation:
[:SOURce]:INPut:TRIGger:SLOPe <Slope>
Sets the polarity of the active slope of an externally applied trigger signal at the trigger
input (BNC connector at the rear of the instrument).
The setting is effective for both inputs at the same time.
Parameters:
<Slope>
Example:
Manual operation:

7.13.6 SOURce:LFOutput Subsystem

The SOURce:LFOutput subsystem contains the commands for setting the LF signal
source in CW and Sweep mode and for analog modulation.
Operating Manual 1407.0806.32 ─ 21
HIGH | G600
HIGH
> 100 k0hm to ground
*RST: HIGH
INP:MOD:IMP HIGH
sets > 100 kOhm to ground.
See "Ext. Impedance"
0 | 1 | OFF | ON
*RST: 0
INP:MOD:WIGN ON
suppresses the overvoltage warnings.
See "Ignore Overvoltage Warning"
NEGative | POSitive
*RST: POSitive
INP:TRIG:SLOP NEG
Activates the falling slope of the external trigger signal at the
trigger input.
See "Ext. Trigger Input Slope"
Remote Control Commands
SOURce Subsystem
on page 201
on page 202
on page 182
348