R&S SMB100A Operating Manual page 475

®
R&S SMB100A
STEReo:DIRect "BK=<Code>"
STEReo:DIRect? "BK"
(for documentation reasons only)
Sets the ARI area identification.
Use SCPI command
Parameters:
<Code>
Example:
Example:
STEReo:DIRect "CT= <Hour>:<Min>:<Sec>,<Day>.<Month>.<Year>"
STEReo:DIRect? "CT"
Sets and activates transmission of the real-time clock.
Note: The CT data is transmitted in group 4A. Setting the real-time clock (CT com-
mand) automatically adds group 4A to the group sequence. Group 4A must not be
manually added to, or removed from, the group sequence. To remove group 4A from
the group sequence, use the command "CT=off".
Setting parameters:
<Hour>:<Min>:<Sec> Range:
<Day>.<Month>.<Year> Range:
Example:
Example:
STEReo:DIRect "CT=off"
Deactivates transmission of the real-time clock signal in the RDS signal.
Note: This command is used to remove group 4A from the group sequence. Group 4A
must not be manually removed from the group sequence.
Example:
Usage:
Operating Manual 1407.0806.32 ─ 21
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
[:SOURce]:STEReo:ARI:BK[:CODE]
A | B | C | D | E | F
STEReo:DIRect "BK=E"
The ARI area identification is set to "E".
STEReo:DIRect? "BK"
Response: "E"
00:00:00 to 23:59:59
01.01.00 to 31.12.85
STEReo:DIRect "CT=20:30:59,01.08.03"
The real-time clock is set to 20:30:59 and 1 August 2003.
STEReo:DIRect? "CT"
Response: "20:31:06,01.08.03"
STEReo:DIRect "CT=off"
The real-time clock signal is no longer transmitted in the RDS
signal.
Setting only
Remote Control Commands
instead.
460