Setting The Rf Frequency; Rf Frequency Dialog; Frequency Settings - R&S SMB100A Operating Manual

®
R&S SMB100A
5.3.2.2

Setting the RF Frequency

To change the RF frequency, press the FREQ key and enter the desired frequency.
Changes to the RF frequency have an immediate effect (without confirmation with the
ENTER key) on the output signal.
RF Freq
Enters the RF frequency, considering the frequency offset.
Note: The SCPI command sets the level of the "Freq" display, that means an entered
frequency offset and multiplier factor are considered in the frequency value.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed]
5.3.2.3

RF Frequency Dialog

The combined "RF Frequency / Phase..." dialog contains the parameters required for
configuring the frequency and settings like a frequency offset, or a multiplier factor of
an externally connected multiplier, see
on page 138.
Furthermore, the dialog provides additional settings parameters which are described
in:
●
Chapter 5.3.3,
5.3.2.4

Frequency Settings

Access:
► Select "RF > config... > RF Frequency > Frequency/Phase".
In the upper section of the combined "RF Frequency / Phase ..." settings dialog,
you can configure the frequency of the RF signal.
Operating Manual 1407.0806.32 ─ 21
Chapter 5.3.2.4, "Frequency
"Phase", on page 140
Instrument Function
on page 341
Settings",
RF Block
138