R&S SMB100A Operating Manual page 194

®
R&S SMB100A
Stop Freq - Frequency Sweep
Sets the stop frequency.
Remote command:
[:SOURce<hw>]:FREQuency:STOP
Center Freq - Frequency Sweep
Sets the center frequency.
Remote command:
[:SOURce<hw>]:FREQuency:CENTer
Span - Frequency Sweep
Sets the span.
Remote command:
[:SOURce<hw>]:FREQuency:SPAN
Current Freq - Frequency Sweep
Displays the current frequency.
In sweep "Step" mode, the parameter is editable and you can enter frequency for the
next step.
Remote command:
[:SOURce<hw>]:FREQuency:MANual
Spacing - Frequency Sweep
Selects the mode for the calculation of the frequency sweep intervals.
"Linear"
"Logarithmic"
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing
Shape - RF Frequency Sweep
Selects the waveform shape of the sweep signal.
"Sawtooth"
"Triangle"
Operating Manual 1407.0806.32 ─ 21
on page 346
on page 345
Takes the frequency value entered as an absolute value in Hz.
Takes the value entered as a lograithmic value, that means as a con-
stant fraction of teh current frequency in %.
One sweep runs from start to stop frequency. Each subsequent
sweep starts at the start frequency, that means the shape of the
sweep sequence resembles a sawtooth.
The sweep runs from the start to the stop frequency and back, that
means the shape of the sweep resembles a triangle. Each subse-
quent sweep starts at the start frequency.
on page 341
on page 342
on page 423
Instrument Function
RF Block
179