Rf Level Sweep - R&S SMB100A Operating Manual

®
R&S SMB100A
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:OVOLtage:STARt
Output Voltage Stop - RF Frequency Sweep
Sets the voltage at the sweep stop frequency.
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:OVOLtage:STOP
Ext. Trigger Input Slope
Sets the polarity of the active slope of an externally applied instrument trigger.
This setting affects the INST TRIG input (BNC connector at the rear of the instrument).
"Positive"
"Negative"
Remote command:
[:SOURce]:INPut:TRIGger:SLOPe
5.3.7.3

RF Level Sweep

To open the "Level Sweep" menu, select "RF > Configure > Level Sweep" or use the
MENU key under "RF".
RF Level Sweep Settings
In the top section, the RF level sweep is activated and the sweep mode is selected.
The buttons are used to reset the level sweep (all sweep modes) or to execute the
level sweep ("Single" mode).
The sweep range, sweep spacing and dwell time are set in the bottom section.
State - Level Sweep
Activates Level Sweep mode.
Note:
Activating a sweep mode automatically deactivates other sweeps and the list mode.
Operating Manual 1407.0806.32 ─ 21
activates the rising edge of the trigger signal.
activates the falling edge of the trigger signal.
on page 421
on page 348
Instrument Function
RF Block
on page 420
182