Table of Contents
Advertisement
®
R&S
SMB100A
Query parameters:
<z>
Example:
Example:
Example:
STEReo:DIRect "ARI=<State>"
STEReo:DIRect? "ARI"
(for documentation reasons only)
Activates ARI signal transmission.
Use SCPI command
Setting parameters:
<State>
Example:
Example:
STEReo:DIRect "ARI-DEV=<Deviation>"
STEReo:DIRect? "ARI-DEV"
(for documentation reasons only)
Sets the frequency deviation of the ARI signal (max. deviation).
Use SCPI command
Setting parameters:
<Deviation>
Example:
Example:
Operating Manual 1407.0806.32 ─ 21
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
AF list to be read
Range:
1 to 5
STEReo:DIRect "AF=N,97.4,98.3"
Defines an alternative frequency list, the alternative frequencies
97.4 and 98.3 are inserted.
STEReo:DIRect? "AF1"
Reads the first alternative frequency list.
Response: "97.4,98.3"
STEReo:DIRect "AF=N"
Deletes all frequency lists.
[:SOURce]:STEReo:ARI:STATe
0 | 1
STEReo:DIRect "ARI=0"
Deactivates ARI signal transmission.
STEReo:DIRect? "ARI"
Response: "0"
[:SOURce]:STEReo:ARI[:DEViation]
Sets the frequency deviation.
Note: A four-digit value must always be set. Leading zeros, if
any, must also be specified.
Range:
0000 to 1000 (ASCII coded decimal numbers),
corresponding to 0 Hz to 10 kHz
STEReo:DIRect "ARI-DEV=1000"
Sets the ARI frequency deviation to 10 kHz.
STEReo:DIRect? "ARI-DEV
Response: "1000"
Remote Control Commands
instead.
instead.
458
Advertisement
Chapters
Table of Contents
