®
R&S
SGU100A
● To connect an external computer for manual control of the instrument by the
R&S SGMA-GUI software.
● To operate the device by a remote control program.
See
Chapter 5.2, "Network and Remote Control
This section describes how to configure the LAN interface. It includes the follow-
ing topics:
●
Chapter 2.3.2.1, "Connecting the Instrument to the
●
Chapter 2.3.2.2, "Assigning the IP
●
Chapter 2.3.2.3, "Automatically Adding Instruments to the SGMA-GUI
on page 24
2.3.2.1
Connecting the Instrument to the Network
There are two methods to establish a LAN connection to the instrument:
● A non-dedicated network (Ethernet) connection from the instrument to an
existing network.
● A dedicated network connection (Point-to-point connection) between the
instrument and a single computer.
In both cases, an IP address has to be assigned to the instrument and the com-
puter, see
Chapter 2.3.2.2, "Assigning the IP
Risk of network failure
Consult your network administrator before performing the following tasks:
● Connecting the instrument to the network
● Configuring the network
● Changing IP addresses
Errors can affect the entire network.
Setting up a non- dedicated network (LAN) connection
► Connect the instrument to the network or to a single PC.
If the instrument is connected to the LAN, the operating system automatically
detects the network connection and activates the required drivers.
Getting Started 1418.2070.02 ─ 08
Connecting an External PC and Devices
Operation",
Address",
on page 22
Address",
Preparing for Use
on page 46.
Network",
on page 21
on page 22.
",
21