Trigger<Hw>:Psweep:source; Trigger<Hw>:Psweep[:Immediate] - R&S SMB100A Operating Manual

®
R&S SMB100A
The command is effective in sweep mode "Single" (LFO:SWE:MODE AUTO in combina-
tion with TRIG:LFFS:SOUR SING).
Usage:
Manual operation:
:TRIGger<hw>:PSWeep:SOURce <Source>
Sets the trigger source for the RF level sweep.
The names of the parameters correspond directly to the various settings under manual
control. SCPI uses other names for the parameters; these names are also accepted by
the instrument. The SCPI names should be used if compatibility is an important consid-
eration.
An overview of the various names is given in
Parameters:
<Source>
Example:
Manual operation:
:TRIGger<hw>:PSWeep[:IMMediate]
Immediately starts an RF level sweep.
The command is only effective for sweep mode "Single" (SOURce:SWEep:POWer:
MODE AUTO in combination with TRIG:PSW:SOUR SING).
The command corresponds to the manual control "Execute Single Sweep".
Operating Manual 1407.0806.32 ─ 21
Event
See "Execute Single Sweep"
AUTO | IMMediate | SINGle | BUS | EXTernal | EAUTo
AUTO|IMMediate
The trigger is free-running, i.e. the trigger condition is fulfilled
continuously. As soon as one sweep is finished, the next sweep
is started.
SINGle|BUS
One complete sweep cycle is triggered by the GPIB commands
[:SOURce<hw>]:SWEep:POWer:EXECute,
PSWeep[:IMMediate]
AUTO (:SOURce:SWEep:LEVel:MODE AUTO).
EXTernal
The sweep is triggered externally via the INST TRIG connector.
EAUTo
The sweep is triggered externally via the INST TRIG connector.
As soon as one sweep is finished, the next sweep is started. A
second trigger event stops the sweep at the current frequency, a
third trigger event starts the trigger at the start frequency, and so
on.
*RST: AUTO
TRIG:PSW:SOUR EXT
selects triggering with an external trigger.
See "Mode - Level Sweep"
Remote Control Commands
TRIGger Subsystem
on page 223
Table 7-2.
or *TRG. The mode has to be set to
on page 183
:TRIGger<hw>:
453