Source:frequency Subsystem - R&S SMB100A Operating Manual

®
R&S SMB100A
Parameters:
<Source>
Example:
Manual operation:
[:SOURce<hw>]:FM:STATe <State>
Activates frequency modulation.
Note: Activation of FM deactivates phase modulation (PM).
Parameters:
<State>
Example:
Manual operation:

7.13.4 SOURce:FREQuency Subsystem

This subsystem contains the commands used to define the frequency settings for the
RF sources and sweeps.
[:SOURce<hw>]:FREQuency:CENTer
[:SOURce<hw>]:FREQuency[:CW|FIXed]
[:SOURce<hw>]:FREQuency[:CW|FIXed]:RCL
[:SOURce<hw>]:FREQuency:MANual
[:SOURce<hw>]:FREQuency:MODE
[:SOURce<hw>]:FREQuency:MULTiplier
[:SOURce<hw>]:FREQuency:OFFSet
[:SOURce<hw>]:FREQuency:SPAN
[:SOURce<hw>]:FREQuency:STARt
[:SOURce<hw>]:FREQuency:STOP
[:SOURce<hw>]:FREQuency:STEP[:INCRement]
[:SOURce<hw>]:FREQuency:STEP:MODE
Operating Manual 1407.0806.32 ─ 21
INTernal | EXTernal | INT,EXT
INT
Uses the internally generated signal for modulation. To configure
the frequency, use the commands of the
"SOURce:LFOutput Subsystem",
EXT
Uses an externally applied modulation signal.
The external signal is input at the MOD EXT connector.
INT,EXT
Uses both, the internal and external modulation signals.
*RST: INT
FM:SOUR INT
selects the internal modulation source.
See "FM Source" on page 203
0 | 1 | OFF | ON
*RST: 0
FM:STAT ON
Activates FM modulation.
See "State" on page 203
..............................................................................341
.........................................................................341
................................................................. 342
..............................................................................342
................................................................................343
..........................................................................344
.............................................................................. 344
.................................................................................345
................................................................................345
.................................................................................346
............................................................. 346
...................................................................... 347
Remote Control Commands
SOURce Subsystem
Chapter 7.13.6,
on page 348 subsystem.
340