Putting Into Operation - R&S SMB100A Operating Manual

®
R&S SMB100A
PULSE EXT
Input of external pulse signal or input of external trigger/gate signal for internal pulse
generator.
See
REF OUT
Output of internal reference signal.
See also
REF IN
Input for external reference signal.
See also
OCXO
●
Oven-controlled reference oscillator (option R&S SMB-B1)
or
●
high performance oven-controlled reference oscillator (option R&S SMB-B1H)
The OCXO generates a very precise 10 MHz reference signal. It needs some minutes
of warm-up time to reach its nominal frequency.
Refer also to the data sheet for detailed information.

2.3 Putting into Operation

This section describes the basic steps to be taken when setting up the R&S SMB for
the first time.
Risk of injury and instrument damage
The instrument must be used in an appropriate manner to prevent electric shock, fire,
personal injury, or damage.
●
Do not open the instrument casing.
●
Read and observe the "Basic Safety Instructions" delivered as a printed brochure
with the instrument.
In addition, read and observe the safety instructions in the following sections.
Notice that the data sheet may specify additional operating conditions.
Operating Manual 1407.0806.32 ─ 21
alsoChapter 5.4.5, "Pulse Modulation
Chapter 5.3.4, "Reference
Chapter 5.3.4, "Reference
(PM)", on page 209 .
Oscillator", on page 141.
Oscillator", on page 141.
Preparing for Use
Putting into Operation
24