R&S SMB100A Operating Manual page 200

®
R&S SMB100A
"Extern Start/Stop"
Remote command:
[:SOURce<hw>]:SWEep:POWer:MODE
:TRIGger<hw>:PSWeep:SOURce
[:SOURce<hw>]:POWer:MODE
Reset Sweep - Level Sweep
Resets the sweep. The start level is set and the next sweep starts from there.
Remote command:
[:SOURce<hw>]:SWEep:RESet[:ALL]
Execute Single Sweep - Level Sweep
Triggers the sweep manually. A manual sweep can only be triggered if "Mode Single"
is selected.
Example:
SOUR:SWE:POW:MODE AUTO
TRIG:PSW:SOUR SING
SOUR:POW:MODE SWE
SOUR:SWE:EXEC
Remote command:
[:SOURce<hw>]:SWEep:POWer:EXECute
:TRIGger<hw>:PSWeep[:IMMediate]
:TRIGger<hw>[:SWEep][:IMMediate]
Start Level - Level Sweep
Sets the start level.
Remote command:
[:SOURce<hw>]:POWer:STARt
Operating Manual 1407.0806.32 ─ 21
Sets an automatically repeated sweep cycle that is started, stopped
and restartet by subsequent external trigger events.
The first external trigger signal starts the sweep (Start).
The next external trigger signal stops the sweep at the current fre-
quency (Stop).
The third external trigger signal starts the sweep at the start fre-
quency (Start).
Refer to the description of the rear panel for information about the
connectors for external trigger signal input (see section "Legend for
Rear Panel View").
Example:
SOUR:SWE:POW:MODE AUTO
TRIG:PSW:SOUR EAUT
SOUR:POW:MODE SWE (External trigger)
on page 453.
on page 382
on page 385
on page 425
on page 429
on page 425
on page 453
on page 455
Instrument Function
RF Block
185