Sav; Sre; Stb; Trg - R&S SMB100A Operating Manual

®
R&S SMB100A
*SAV <Number>
Save
Stores the current instrument settings under the specified number in an intermediate
memory. The settings can be recalled using the command
number.
To transfer the stored instrument settings in a file, use the command
STORe:STATe.
Manual operation:
*SRE <Contents>
Service request enable
Sets the service request enable register to the indicated value. This command deter-
mines under which conditions a service request is triggered.
Parameters:
<Contents>

*STB?

Status byte query
Reads the contents of the status byte in decimal form.
Usage:

*TRG

Trigger
Triggers all actions waiting for a trigger event. In particular, *TRG generates a manual
trigger signal. This common command complements the commands of the TRIGger
subsystem.
Usage:
Manual operation:

*TST?

Self-test query
Initiates self-tests of the instrument and returns an error code
Operating Manual 1407.0806.32 ─ 21
See "Save" on page 128
Contents of the service request enable register in decimal form.
Bit 6 (MSS mask bit) is always 0.
Range: 0 to 255
Query only
Event
See "Execute Single Trigger"
Remote Control Commands
Common Commands
with the associated
*RCL
:MMEMory:
on page 229
283