Lf Frequency Sweep - R&S SMB100A Operating Manual

®
R&S SMB100A
Remote command:
[:SOURce]:LFOutput<ch>:FREQuency
LF Gen Shape
Selects the waveform shape of the LF signal.
Note: The installed hardware determines the available settings. Use the
Config
For information on the required hardware revision, refer to the release notes.
Remote command:
[:SOURce]:LFOutput:SHAPe
LF Source Impedance
Selects the output impedance of the LF generator. Selection LOW and 600 Ohm are
available.
Note: The installed hardware determines the available settings. Use the
Config
For information on the required hardware revision, refer to the release notes.
Remote command:
[:SOURce]:LFOutput:SIMPedance

5.5.3 LF Frequency Sweep

The "LF Frequency Sweep" dialog is used to configure and activate an LF frequency
sweep signal.
To open the "LF Frequency Sweep" dialog, select "Mod Gen > Configure > LF Fre-
quency Sweep" or use the MENU key under "Mod Gen".
The LF sweep mode is activated and the sweep mode is selected. The buttons are
used to reset the LF sweep (all sweep modes) or to execute the LF sweep ("Single"
mode).
The sweep range, sweep spacing and dwell time are set in the bottom of the section.
Operating Manual 1407.0806.32 ─ 21
dialog to check the hardware the instrument is equipped with.
dialog to check the hardware the instrument is equipped with.
Modulation Generator and LF Output
on page 349
on page 357
on page 358
Instrument Function
Hardware
Hardware
220