R&S SMB100A Operating Manual page 399

®
R&S SMB100A
the power control locks and tries to achieve the target level. Readings outside the
range are not considered.
Parameters:
<PowCntrlCRange> float
Example:
Manual operation:
[:SOURce<hw>]:POWer:SPC:DELay <PowCntrlDelay>
Defines a waiting period between the level adjustment of the generator and the next
measurement of the power sensor.
Parameters:
<PowCntrlDelay>
Example:
Manual operation:
[:SOURce<hw>]:POWer:SPC:PEAK <PowCntrlPeak>
Activates power control by means of the peak power values, provided the power sen-
sor supports this function.
Parameters:
<PowCntrlPeak>
Example:
Manual operation:
[:SOURce<hw>]:POWer:SPC:SELect <PowCntrlSelect>
Defines the currently selected sensor to be used for power control.
Parameters:
<PowCntrlSelect>
Operating Manual 1407.0806.32 ─ 21
Range: 0 to 50
Increment: 0.01
*RST: 30
Default unit: dB
POW:SPC:CRAN 15
sets the capture range to +/- 15 dB.
See "Catch Range +/-"
integer
Range: 0 to 1000
*RST: 0
:POW:SPC:DEL 2 ms
the sensor starts the next reading 2 ms after the level adjust-
ment.
See "Delay Time" on page 157
0 | 1 | OFF | ON
*RST: 0
POW:SPC:PEAK ON
uses the measured peak power for power control.
See "Use Peak Power"
SENS1 | SENS2 | SENS3 | SENS4
*RST: SENS1
Remote Control Commands
SOURce Subsystem
on page 157
on page 157
384