R&S SMB100A Operating Manual page 353

®
R&S SMB100A
[:SOURce<hw>]:FM:EXTernal:DEViation <Deviation>
Sets the deviation of the external frequency modulation signal in Hz. The maximum
deviation depends on the set RF frequency and the selected modulation mode (see
data sheet).
The sum of the deviations of all active frequency modulation signals may not exceed
the total value set with command [:SOURce<hw>]:FM[:DEViation].
Parameters:
<Deviation>
Example:
Manual operation:
[:SOURce<hw>]:FM:INTernal:DEViation <Deviation>
Sets the deviation of the internal frequency modulation signal in Hz.
The sum of the deviations of all active frequency modulation signals may not exceed
the total value set with command [:SOURce<hw>]:FM[:DEViation].
Parameters:
<Deviation>
Example:
Manual operation:
[:SOURce<hw>]:FM:MODE <Mode>
Selects the mode for the frequency modulation.
Operating Manual 1407.0806.32 ─ 21
float
Range: see data sheet
Increment: 0.01
*RST: 1000
FM:EXT:DEV 3kHz
sets 3 kHz deviation to the frequency modulation signal.
See "FM Deviation" on page 204
float
Range: 0 to dynamic
Increment: 0.01
*RST: 1E3
FM:INT1:DEV 2E3
sets 2 kHz deviation for the freqeuncy modulation signal.
See "FM Deviation" on page 204
Remote Control Commands
SOURce Subsystem
338