Table of Contents
Advertisement
®
R&S
SMB100A
:SENSe<ch>[:POWer]:APERture:DEFault:STATe <UseDefAp>
Deactivates the default aperture time of the respective sensor.
To specify a user-defined value, use the command
APERture:TIMe
Parameters:
<UseDefAp>
Example:
Manual operation:
:SENSe<ch>[:POWer]:APERture:TIMe <ApTime>
Defines the aperture time (size of the acquisition interval) for the corresponding sensor.
Parameters:
<ApTime>
Example:
Manual operation:
:INITiate<ch>[:POWer]:CONTinuous <Continuous>
The command switches the local state of the continuous power measurement by the
R&S NRP-Zxx power sensors on and off. Switching the local state off enhances the
measurement performance during remote control
Operating Manual 1407.0806.32 ─ 21
..............................................................................320
................................................................................ 320
...........................................................................321
..................................................................................321
........................................................................................ 322
............................................................................. 322
.................................................................................... 322
.......................................................................................323
......................................................................... 323
....................................................................................323
.......................................................................................... 324
.......................................................................................... 324
............................................................................................324
on page 316.
0 | 1 | OFF | ON
*RST:
1
SENS:POW:APER:DEF:STAT 0
deactivates the default aperture time of the sensor.
See
"Use Default Aperture Time"
float
Range:
depends on connected power sensor
Increment: 1E-9
*RST:
depends on connected power sensor
SENS:POW:APER:TIM 23ms
sets 23 ms aperture time.
See
"Aperture Time"
Remote Control Commands
SENSe, READ and INITiate Subsystems
:SENSe<ch>[:POWer]:
on page 173
on page 173
316
Advertisement
Chapters
Table of Contents
