Rf Level Dialog - R&S SMB100A Operating Manual

®
R&S SMB100A
RF Level
Enters the RF level, considering the level offset (see
on page 145).
dBm, dBµV, mV and µV can be used as the level units. The four unit keys are labeled
with these units.
Note: The SCPI command sets the level of the "Level" display, i.e. an entered level off-
set is considered in the level value.
Remote command:
[:SOURce<hw>]:POWer[:LEVel][:IMMediate][:AMPLitude]
5.3.5.2

RF Level Dialog

Access:
► Select "RF > config... > RF Level > Level/Attenuator".
The offset-free level, level offset and level limit are set in the top section of the dia-
log. The attenuator mode is set in the "Attenuator Settings" section.
In section "User Variation", you can determine the step size for adjusting the level
with the rotary knob (with "Variation Active On").
The power-on behavior of the instrument and the level display in the display
header are set in the "Power-On / EMF Settings" section (see
"Power-On/EMF
The remote commands required to define the settings are described in
ter 7.13.12, "SOURce:POWer
Operating Manual 1407.0806.32 ─ 21
Settings", on page 151).
Subsystem",
Instrument Function
"RF level vs. RF output level"
Chapter 5.3.5.3,
on page 376.
RF Block
on page 379
Chap-
146