Info-Center Synchronous - Huawei Quidway S3900 series Command Manual

Command Manual – Information Center
Quidway S3900 Series Ethernet Switches-Release 1510
Each information channel is configured with a default record, whose module name is
default and module number is 0xffff0000. In the record, the default settings for log, trap
and debugging information may differ with channels. If no record is configured for a
channel, this default record is adopted.
Example
# Configure to output the log information of the VLAN module on the SNMP channel,
and only output the log information above the "emergencies" severity.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] info-center source vlan channel snmpagent log level emergencies

1.1.15 info-center synchronous

Syntax
info-center synchronous
undo info-center synchronous
View
System view
Parameter
None
Description
Use the info-center synchronous command to enable synchronous terminal output,
so that if system information (such as log information) is output when the user is
inputting information, the command prompt and input information are echoed after the
output (note that, the command prompt is echoed in command edit state but is not
echoed in interactive state).
Use the undo info-center synchronous command to disable synchronous terminal
output.
By default, the synchronous terminal output function is disabled.
Huawei Technologies Proprietary
1-17
Chapter 1 Information Center Configuration
Commands