Reset Ndp Statistics - Huawei Quidway S2000 Series Command Manual

Command Manual - Integrated Management
Quidway S2000 Series Ethernet Switches
View
System view
Parameter
aging-in-secs: Specifies how often to refresh the neighbor node information on a port
and ranges from 5 to 255 in units of second. By default, NDP is aged in 180 seconds.
Description
Using ndp timer aging command, you can configure how long a device will hold the
NDP packets received from the local device. After the aging timer expires, the device
will discard the received NDP neighbor node information. Using undo timer aging
command, you can restore the default NDP information aging time.
A user can specify how long an adjacent device will hold the information of the local
device. The adjacent device learns how long it will hold the NDP information from the
aging time carried in NDP packets and discards the packets when the aging timer
expires.
Normally NDP aging time is longer than NDP packet interface. Otherwise, the neighbor
information table of an NDP port will become unstable.
Example
# Configure the aging time of NDP packet as 60, so that an adjacent device will discard
the NDP packets from the local device 60 seconds after receiving them.
[Quidway] ndp timer aging 60

1.1.5 reset ndp statistics

Syntax
reset ndp statistics [ interface port-list ]
View
User view
Parameter
interface port-list Specifies a list of ports isolated from the specified port. A list may
contain consecutive or separated ports, or the combination of consecutive and
separated ports. The parameter is expressed as { interface_type interface_num |
Chapter 1 HGMP V2 Configuration Commands
1-6