FINAL DRIVE
FINAL GEAR CASE SEPARATION
Remove the bolt, washer and the dust guard plate
by turning it clockwise.
Remove the a-ring.
Loosen the cover bolts in a crisscross pattern in sev
eral steps and remove them.
Pry the gear case cover and remove it from the case.
Remove the wave washer.
GEAR TOOTH CONTACT PATTERN
CHECK
Description of the tooth:
COAST SIDE
Keep dust and dirt Clean the sealing material off the mating surfaces of
Apply Prussian Blue
out
of
the case and the gear -case and cover, being careful not to dam-
cover.
age them.
Apply a thin coat of Prussian Blue to the pinion gear
teeth.
Install the wave washer.
GEAR CASE COVER
a-RING
TOE (inside of gear)
(contacts when engine brake is applied)
---------
(contacts when engine power is applied)
WAVE WASHER
14-9