Transmission - Honda CB350 Repair Manual

82 ENGINE AND TRANSMISSION
Kick—starter (CB/CL350)
4. Kick—starter shaft
5. Return spring
6. Circlip
1. Circlip
2. Friction spring
3. Kick—starter gear
Removing the transmission shafts
Be sure that the friction spring is seated properly
in the crankcase (350)
the shaft as shown in the accompanying
illustration. Hold the shaft so that the
stop on the shaft is against the stop in the
lower crankcase when installing the inter—
nal components. Be sure that the ratchet
guide plate (360 models) or the friction
spring (350 models) is seated properlyin
the crankcase.
TRANSMISSION
Removal
1. Split the crankcases as described
previously. The transmission shafts can
be lifted out of the top case.
2. 350 models: Remove the neutral
switch rotor and the drum stopper from
the shift drum. Remove the guide pin
clips and the guide pins from the shift
forks. Mark the location of each shift fork
Removing the shift fork guide pins
(left, center, and right) and slide the shift
drum out of the case from the right—side.
3. 360 models: Remove the shift drum
stopper and stopper spring. Remove the