Map Sensor; Iat Sensor - Honda CRF450R 2009 Service Manual

Disconnect the MAP sensor vacuum hose from the
MAP sensor.
Connect the MAP sensor vacuum hose to the MAP
sensor.
Set the stay to the MAP sensor as shown.
tnstall the MAP sensor/slay by aligning the stay hole
with the lab of the throttle body.
Install and tighten the screw to the specified torque.
TORQUE: 4.9 N'm (0.5 kgf·m. 3.6IbHt)
Connect the MAP sensor 3P (Black) connector.
Instatl the fuel tank (page 4-6).
IAT SENSOR
REMOVAUINSTALLATION ('09 - '12)
Remove the left side cover (page 3-3).
Disconnect the IAT sensor 2P (Gray) connector.
Remove the screws, IAT sensor and O-nng.
Apply engine oil to a new O-ring and install it to the tAT
sensor.
tns tall ihe tAT sensor and screws.
Tighten the screws to the specified torque.
TORQUE: 1.1 N'm (0.1 kgf'm , O.8IbHt)
Connect the IAT sensor 2P (Gray) connector.
Install the left side cover (page 3-3).
FUEL SYSTEM (PGM-FI)
6-71