Setting The Supported Type Of Radius Server; Setting Radius Server State - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches
T able 2-21 S
Set the
stopping a
Restore the maximum retransmitting times of
stopping accounting request to the default
value
By default, the stopping accounting request can be retransmitted for up to 500 times.
2.3.11 Se tting the Supported Type of RADIUS Server
Quidway Series Switches support the standard RADIUS protocol and the extended
RADIUS service platforms, such as IP Hotel, 201+ and Portal, independently
developed by Huawei.
You can use the following command to set the supported types of RADIUS servers.
Perform the following configurations in RADIUS scheme view.
Table 2-22 Setting the supported type of RADIUS server
Setting
RADIUS Server
Restore the Supported Type of
RADIUS Server to the default setting
By default, the newly creat
w hile the "system" RADIUS scheme created by the system supports the server o
huawei type.

2.3.12 Setting RADIUS Server State

For the primary and second servers (no matter it is an authentication/authorization
server or accounting server), if the primary is disconnected to NAS for some fault, NAS
will automatically turn to exchange packets with the second server. However, after the
primary one recovers, NAS will not resume the communication with it at once, instead,
it continues communicating with the second o
communicate, NAS will turn to the primary one again. The following commands can be
used to
communicate with it right after the troubleshooting.
When the primary and second servers are both active or block, NAS will send the
packets to the primary server only.
etting the maxim um
Operation
maximum retran smittin
ccounting request
Operation
the Supported Type
ed RADI
set the primary server to be active manually, in order that NAS can
Huawei Technologies Proprietary
Chapter 2 AAA and RADIUS Protocol
retransmitting times of stopping accounting request
g times of retry
retry-times
undo retry stop-accounting
of server-type { huawei | iphotel | portal |
standard }
undo server-type
US scheme supports the server of standard type,
ne. When the second one fails to
2-17
Configuration
Command
stop-accounting
Command
f