1 Layer 2 Multicast Configuration
1.8.2 Example for Configuring Multicast VLAN Replication
Networking Requirements
As shown in
3. GE 1/0/2 and GE 1/0/3 of the S9300 are connected to hosts, and are respectively added to
VLAN 100 and VLAN 200. It is required that the four hosts connected to the S9300 should
receive the multicast flow from the multicast groups 225.0.0.1 to 225.0.0.3. VLAN 3 is the
multicast VLAN; VLAN 100 and VLAN 200 are user VLANs.
Figure 1-3 Networking diagram for configuring multicast VLAN replication on the S9300
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
1-30
#
return
Figure
1-3, GE 3/0/1 of the S9300 is connected to a router, and is added to VLAN
DHCP server
IP/MPLS core
VLAN3
GE1/0/2
VLAN100
Create a multicast VLAN.
Create user VLANs.
Configure the mapping the multicast VLAN and the user VLANs.
Configure the VLAN that the interfaces of the S9300 belong to and static multicast entries.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Multicast source
GE3/0/1
S9300
GE1/0/3
VLAN200
Quidway S9300 Terabit Routing Switch
Configuration Guide - Multicast
Issue 01 (2009-07-28)