Configure Router Port Aging Time; Configure Maximum Response Time; Configure Aging Time Of Multicast Group Member - Huawei Quidway S3000-EI Series Operation Manual

Operation Manual - Multicast
Quidway S3000-EI Series Ethernet Switches
IGMP Snoop
r unning, using the display gmrp s
S nooping.
By default, IGMP Snooping is disabled.
2.2.2 Con figure Router Port Aging Time
This task is to manually configure the router port aging time. If the switch has not
received an
will remove the port from all the MAC mu
Perform the following configuration in system view.
Table 2-2 Configure router port aging time

Configure router port aging time

Restore the default aging time
By default, the port aging time is 260s.

2.2.3 Configure Maximum Response Time

This t ask is to manually configur
receives no
th e port from the multicast group.
Perform the following configuration in sy
Table 2-3 Configure the maximum response time
Configure the maximum response
time
Restore the default setting
By default, the maximum response time is 10 seconds.
2.2.4 Configure Agi
T his task is to manually set the agin
swit ch receives no multicast group rep
ing and GM RP cannot run at the same tim
y general query message from the router before the router port is aged, it
Operation
e the maxi
report message from a port in the maxim
Operation
ng Time o f Multicast Group Mem
Huawei Technologies Proprietary
Chapter 2 IGMP Snooping Configuration
tat us command, in any view, before enab
lticast group.
Command
igmp-snooping router-aging-time seconds
undo igmp-snooping router-aging-time
mum response time. If the Ethernet swit
um response time, it will remove
stem view.
Command
igmp-snooping
seconds
undo igmp-snooping max-response-time
ber
g time of the multic
ort messa ge during the member port aging time,
2-5
e. You can che ck if GMRP is
ling IGMP
max-response-time
ast gro up member port. If the
ch