Configuring Link Aggregation In Manual Load Balancing Mode; Establishing The Configuration Task - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
Active Interface and Inactive Interface
Active interfaces refer to the interfaces that are in active state and are responsible for forwarding
data. The interfaces that do not forward data and are in inactive state are called inactive interfaces.
According to the operation modes, active and inactive interfaces are classified as follows:
l
l
Actor and Partner
In static LACP mode, the device in the link aggregation group with a higher LACP priority is
the Actor and the device with a lower LACP priority is the Partner.
If the two devices have the same LACP priority, the Actor is selected based on the MAC
addresses of the devices. The device with a smaller MAC address becomes the Actor.
Differentiating the Actor and the Partner is to keep the active interfaces of devices at both ends
consistent. If the devices at both ends select active interfaces according to the priority of their
own interfaces, the active interfaces may be different and the active links cannot be set up.
Therefore, the Actor is first determined. The Partner selects active interfaces according to the
priority of the interfaces of the Actor.
Figure 2-1 Determining the active links in static LACP mode
SwitchA
Device with high
SwitchA
2.3 Configuring Link Aggregation in Manual Load
Balancing Mode
This section describes how to configure link aggregation in manual load balancing mode.

2.3.1 Establishing the Configuration Task

Issue 01 (2011-07-15)
Manual load balancing mode: Generally, all member interfaces are active interfaces unless
a fault occurs on these interfaces.
Static LACP mode: The interfaces connected to M links are active interfaces that are
responsible for forwarding data; the interfaces connected to N links are inactive interfaces
that are used for redundancy backup.
priority
Active interface selected by SwitchA
Active interface selected by SwitchB
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 2-1 shows the process of selecting active interfaces.
Device with low
The Actor determines
the active link
2 Link Aggregation Configuration
SwitchB
priority
SwitchB
19