Toshiba e-STUDIO2500c Service Manual page 317

[E] Transfer belt motor (M7)
Note:
Never remove the damper fixed on the transfer belt motor unit with 2 screws (red).
When the transfer belt motor is replaced, discard the dumper attached to the new motor and
install it to the existing dumper on the frame instead.
(1) Take off the ozone exhaust fan.
P.12-30 "[O] Ozone exhaust fan (M24)"
(2) Remove 1 spring.
(3) Remove 3 screws, and then disconnect the
connector to take off the transfer belt motor.
(4) Release the upper hook to take off the trans-
fer belt motor unit.
Note:
When installing the transfer belt motor, make
sure that the TBU separation lever is at the
fixed position (horizontal position) with the
transfer belt unit installed. Secure the hook
of the transfer belt motor unit onto the equip-
ment and fix it with 3 screws temporarily.
Attach the spring to apply tension and tighten
the 3 screws.
(5) Remove 2 screws and take off the transfer
belt motor.
May 2006 © TOSHIBA TEC
Connector
Spring
Fig. 13-55
Fig. 13-56
Transfer belt motor
Fig. 13-57
e-STUDIO2500c/3500c/3510c TRANSFER UNIT
13 - 29
Hook
Transfer belt motor unit
13