Toshiba e-STUDIO2500c Service Manual page 184

(9) Remove 2 screws, slide the shutter unit to
the front, and then pull it out to the exit side.
[D] Shutter motor (M12)
(1) Take off the shutter unit.
P.8-14 "[C] Shutter unit"
(2) Disconnect 1 connector, remove 3 screws
and take off the shutter motor with the
bracket.
(3) Remove the E-ring. Then remove 1 gear, 1
spring and 1 polyslider.
Note:
When assembling the unit, be sure to install
the polyslider.
e-STUDIO2500c/3500c/3510c LASER OPTICAL UNIT
Shutter unit
8 - 16
Fig. 8-21
Shutter motor
Fig. 8-22
Gear
Spring
Polyslider
Fig. 8-23
May 2006 © TOSHIBA TEC