Toshiba e-STUDIO2500c Service Manual page 384

[L] Lower transport roller
(1) Take off the ADU board and ADU cover.
P.16-15 "[E] ADU board (ADU)"
P.16-16 "[F] ADU cover"
(2) Remove 2 clips, 2 pulleys and 2 pins on the
front side. Then take off the belt.
(3) Remove 1 clip and 1 bushing on the rear
side.
(4) Remove 1 bushing on the front side. Then
take off the lower transport roller.
[M] ADU entrance sensor (S38)
(1) Take off the ADU cover.
P.16-16 "[F] ADU cover"
(2) Disconnect 1 connector. Release the latches
and take off the ADU entrance sensor.
e-STUDIO2500c/3500c/3510c AUTOMATIC DUPLEXING UNIT (ADU)
Belt
Pin
Lower transport roller
Bushing
Clip
16 - 20
Pin
Pulley
Clip
Clip
Pulley
Fig. 16-28
Fig. 16-29
ADU entrance sensor
Fig. 16-30
May 2006 © TOSHIBA TEC
Bushing