Toshiba e-STUDIO2500c Service Manual page 378

[B] Automatic Duplexing Unit (ADU)
(1) Take off the right rear hinge cover.
P.2-32 "[L] Right rear hinge cover"
(2) Disconnect 1 connector and remove 1 screw
fixing the ground wires.
(3) Remove 1 screw of the front hinge, and then
take off the automatic duplexing unit by lifting
it up slightly and sliding it to the rear side.
Note:
When installing the ADU, match the front and
rear hinge bosses of the equipment and the
hinge holes of the ADU.
e-STUDIO2500c/3500c/3510c AUTOMATIC DUPLEXING UNIT (ADU)
Ground wire
Screw
16 - 14
Connector
Fig. 16-10
Automatic duplexing unit
Fig. 16-11
Automatic
duplexing unit
Hole Boss
Boss Hole
Fig. 16-12
May 2006 © TOSHIBA TEC