Toshiba e-STUDIO2500c Service Manual page 364

[G] Fuser/exit section cooling fan (M25) / Exit motor (M18)
(1) Take off the exit section drive unit.
P.15-39 "[F] Exit section drive unit"
(2) Remove 2 screws and take off the fuser/exit
section cooling fan.
(3) Remove 2 E-rings 1 pully and 1 belt and take
off the exit motor.
Notes:
• Replace the rexit motor with the bracket
installed.
• Never attempt to loosen 2 screws fixing
exit motor.
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
Screw
Exit motor
15 - 40
Fuser/exit section cooling fan
Fig. 15-72
Belt
Pully
Fig. 15-73
May 2006 © TOSHIBA TEC