[A-12] Fuser belt center thermostat (THMO1)
(1)
Take off the front side cover, pressure roller
cover and transport guide.
P.15-18 "[A-2] Front side cover"
P.15-18 "[A-4] Pressure roller cover"
P.15-19 "[A-5] Transport guide""
(2)
Release the harness out of 2 terminals of the
fuser belt center thermostat.
(3)
Remove 3 screws and take off the fuser belt
center thermostat.
Notes:
•
When installing them, fix the thermostat,
and then fix the terminal of the harness.
•
Check that the gap between the fuser belt
center thermostat and the fuser belt is 1.6
- 2.4 mm while they are being pushed
each other, through the opening.
May 2006 © TOSHIBA TEC
Harness
Fuser belt center thermostat
Fig. 15-47
Fuser belt
center thermostat
Fig. 15-48
Fuser belt center
thermostat ( THMO1 )
Fuser belt
1.6 - 2.4 mm
Fig. 15-49
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
15 - 31
15