Toshiba e-STUDIO2500c Service Manual page 231

[W] 2nd drawer transport roller
(1) Take off the paper feed guide assembly.
P.10-32 "[G] Paper feed guide assembly"
(2) Take off the tray drive unit.
P.10-30 "[C-2] Tray drive unit"
(3) Take off the 2nd drawer transport clutch (low
speed).
P.10-30 "[D] 2nd drawer transport clutch
(Low speed) (CLT4)"
(4) Remove 1 clip, and then remove the gear
and parallel pin.
(5) Remove 2 clips, and then take off the 2nd
drawer transport roller by moving it to the
rear side slightly.
May 2006 © TOSHIBA TEC
Pin
Gear
Clip
Fig. 10-87
Fig. 10-88
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
10 - 43
2nd drawer transport roller
10