Toshiba e-STUDIO2500c Service Manual page 229

[S] Feed/transport motor (M20)
(1) Open the board case.
P.2-43 "[K] Board case"
(2) Disconnect 1 connector and remove 2
screws to take off the feed/transport motor.
[T] Feed/transport gear unit
(1) Take off the feed/transport motor.
P.10-41 "[S] Feed/transport motor (M20)"
(2) Take off the 1st drawer transport clutch (Low
speed).
P.10-40 "[R] 1st drawer transport clutch
(Low speed) (CLT2)"
(3) Disconnect 1 connector, and then release
the harness out of the clamp.
(4) Remove 4 screws, and then take off the
feed/transport gear unit.
May 2006 © TOSHIBA TEC
Feed/transport motor
Fig. 10-83
Feed/transport gear unit
Fig. 10-84
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
10 - 41
10