(3)
Remove 2 screws and take off the used
toner motor.
[H] Developer unit motor (M9)
(1)
Take off the switching regulator.
P.2-41 "[G] Switching regulator"
(2)
Open the board case.
P.2-43 "[K] Board case"
(3)
Remove 2 screws. Disconnect the 1 connec-
tor and take off the developer unit motor.
[I]
Developer drive unit
(1)
Take off the switching regulator and drum
drive unit.
P.2-41 "[G] Switching regulator"
P.11-20 "[F] Drum drive unit"
(2)
Remove 1 screw on the right side of the
developer drive unit.
e-STUDIO2500c/3500c/3510c DEVELOPER UNIT
Developer unit motor
Developer drive unit
12 - 26
Used toner motor
Fig. 12-51
Connector
Fig. 12-52
Fig. 12-53
May 2006 © TOSHIBA TEC