Toshiba e-STUDIO2500c Service Manual page 308

[B-4] 1st transfer roller
(1) Take off the transfer belt.
P.13-16 "[B-2] Transfer belt"
(2) Rotate the gear of the 1st transfer roller cam
motor with your fingers to move 6 lift levers
up.
(3) Remove 4 screws.
(4) Then remove 4 of the 1st transfer rollers and
4 front terminals.
[B-5] 2nd transfer facing roller / 2nd transfer facing roller cleaning mylar
(1) Take off the transfer belt.
P.13-16 "[B-2] Transfer belt"
(2) Remove 2 screws, and then take off the 2nd
transfer facing roller front holder. Then take
off the 2nd transfer facing roller and 1 bear-
ing.
Note:
Be sure not to damage the earth plate of 2nd
transfer facing roller rear holder.
e-STUDIO2500c/3500c/3510c TRANSFER UNIT
Lift lever
Front terminal
Bearing
2nd transfer facing roller
2nd transfer facing roller front holder
13 - 20
Gear
Fig. 13-28
1st transfer roller
Fig. 13-29
Bearing
Fig. 13-30
May 2006 © TOSHIBA TEC