Toshiba e-STUDIO2500c Service Manual page 208

(3) Take off the sensor arm.
(4) Disconnect the connector from the sensor
and release the latch to take off the bypass
paper sensor.
[A-8] Bypass pickup roller
(1) Take off the bypass upper guide.
P.10-18 "[A-5] Bypass upper guide"
(2) Remove the clip, pull out the shaft and take
off the bypass pickup roller.
Notes:
Make sure the following items when assem-
bling the bypass pickup roller.
1. Set the timing belt to the pulley securely.
2. Do not put the wrong position when set-
ting the timing belt.
3. Be sure to insert the clip into the groove
of shaft.
4. Check that there is no stain such as oil on
the surface of timing belt, the pulley and
the roller.
5. Install the bypass pickup roller and the
bypass feed roller in the correct direction.
e-STUDIO2500c/3500c/3510c PAPER FEEDING SYSTEM
Bypass pickup roller
10 - 20
Sensor arm
Fig. 10-25
Bypass paper sensor
Fig. 10-26
Shaft
Fig. 10-27
May 2006 © TOSHIBA TEC
Clip