[A-13] Fuser belt rear thermostat (THMO2)
(1)
Take off the front side cover, pressure roller
cover and transport guide.
P.15-18 "[A-2] Front side cover"
P.15-18 "[A-4] Pressure roller cover"
P.15-19 "[A-5] Transport guide"
(2)
Release the harness out of 2 terminal of the
fuser belt rear thermostat.
(3)
Remove 2 screws and take off the fuser belt
rear thermostat.
Notes:
•
When installing them, fix the thermostat,
and then fix the terminal of the harness.
•
Check that the gap between the fuser belt
rear thermostat and the fuser belt is 1.6
mm - 2.4 mm while they are being pushed
each other, through the opening.
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
Harness
Fuser belt rear thermostat
Fuser belt rear thermostat
Fuser belt
rear thermostat ( THMO2 )
Fuser belt
1.6~2.4 mm
15 - 32
Harness
Fig. 15-50
Fig. 15-51
Fig. 15-52
May 2006 © TOSHIBA TEC