Toshiba e-STUDIO2500c Service Manual page 306

(8) Pull out the transfer belt.
Notes:
1. Install the transfer belt in the middle so
that it does not move to one side.
2. Install the transfer belt with the reflection
tape on the inner side of the belt come at
the rear side.
3. Do not touch the belt surface directly with
bare hands.
4. Be sure not to scratch the belt surface.
5. When the belt is being replaced, clean its
drive roller, 2nd transfer facing roller, ten-
sion roller and idling roller with alcohol.
6. Check if the rib on both ends of the trans-
fer belt does not run on the rollers.
7. After the transfer belt has been installed,
apply the tension to the transfer belt by
pushing the stopper of the tension roller. If
the tension is not applied, the transfer belt
may deviate to cause unstable image.
[B-3] Drive roller / Drive roller cleaning mylar
(1) Take off the transfer belt.
P.13-16 "[B-2] Transfer belt"
(2) Remove 1 E-ring, 1 bearing on the front side
of the drive roller.
(3) Take off the drive roller.
e-STUDIO2500c/3500c/3510c TRANSFER UNIT
Bearing
Drive roller
13 - 18
Transfer belt
Fig. 13-22
Fig. 13-23
Fig. 13-24
May 2006 © TOSHIBA TEC