Bypass Feed Copying; Interruption Copying - Toshiba e-STUDIO2500c Service Manual

4.2.4

Bypass feed copying

1) Insert a paper into the bypass tray.
→ Bypass paper sensor (S40) is turned ON.
- "Ready for bypass feeding" is displayed.
→ Carriages move to the home position.
2) Press the [START] button ON
→ "Ready for bypass feeding" changes to "COPYING".
→ Exposure lamp (EXP) ON
→ Scan motor (M1) ON→Carriages-1 and -2 move forward.
→ Drum motor (M10), transfer belt motor (M7), transport motor (M20), developer unit motor (M9),
fuser motor (M17) and exit motor (M18) turned ON
- The drum, transfer belt, fuser unit, developer unit and exit roller are driven.
3) Bypass feeding
→ Fans rotate in high speed.
→ Bypass feed clutch (CLT8) turned ON.
- The bypass pickup roller is lowered.
→ Bypass pickup solenoid (SOL1) turned ON.
- The bypass pickup roller, feed roller and separation roller start to rotate.
→ Aligning operation
→ Paper reaches the registration roller.
→ After a certain period of time, the bypass feed clutch (CLT8) turned OFF.
4) Hereafter, operations (3) through (6) of "4.2.3. Drawer feed copying" are repeated.
4.2.5

Interruption copying

1) Press the [INTERRUPT] button
→ LED "INTERRUPT" is turned ON.
→ Copying operation in progress is temporarily stopped, and the carriages-1 and -2 return to appro-
priate positions.
→ "Job interrupted job 1 saved" is displayed.
→ Automatic density and reproduction ratio 100% are set. Set number remains the same.
2) Select the desired copy condition
3) After interruption copying is finished:
→ "Press interrupt to resume job 1" is displayed.
→ LED "INTERRUPT" is turned OFF by pressing the [INTERRUPT] button, and the equipment
returns to the status before the interruption.
→ "Ready to resume job 1" is displayed.
4) Press the [START] button
The copying operation before the interruption is resumed.
May 2006 © TOSHIBA TEC e-STUDIO2500c/3500c/3510c GENERAL OPERATION
4 - 7
4