Toshiba e-STUDIO2500c Service Manual page 150

[C-2] LT series (APS-1, -3, -C, -R)
(1) Take off the original glass.
P.6-18 "[A] Original glass"
(2) Disconnect 1 connector and remove 1 screw
for each APS sensor. Take off 4 APS sen-
sors.
[D] Exposure lamp (EXP)
(1) Take off the original glass and front upper
cover.
P.6-18 "[A] Original glass"
P.2-28 "[D] Front upper cover"
(2) Move the carriage-1 to the center position.
(3) Disconnect the connector of the exposure
lamp.
Note:
When disconnecting the connector, pay
attention not to give load to the carriage
frame.
(4) Release the harness from the harness
clamp.
e-STUDIO2500c/3500c/3510c SCANNER
6 - 20
Fig. 6-22
Fig. 6-23
Fig. 6-24
May 2006 © TOSHIBA TEC