Toshiba e-STUDIO2500c Service Manual page 353

[A-11] Pressure roller center thermistor (THM4) / Pressure roller rear thermistor (THM5)
(1) Take off the heat roller cover.
P.15-26 "[A-10] Pressure roller thermostat
(THMO3)"
(2) Release the harness out of the 5 clamps.
(3) Remove the 2 screws of each thermistor,
and then take off the both brackets of the
pressure roller center thermistor and the
pressure roller rear thermistor.
(4) Remove 2 screws and take off the pressure
roller center thermistor.
(5) Remove 1 screw and take off the pressure
roller rear thermistor.
May 2006 © TOSHIBA TEC
Pressure roller
rear thermistor bracket
Clamp
Pressure roller
center thermistor bracket
Fig. 15-42
Pressure roller rear
Pressure roller
thermistor center thermistor
Fig. 15-43
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
15 - 29
Clamp
Clamp
15