Toshiba e-STUDIO2500c Service Manual page 351

(4) Remove 4 screws and take off the heat roller
cover.
(5) Remove 1 screw. Release the harness out of
the 6 clamps, and take off the pressure roller
thermostat bracket.
(6) Remove 2 screws, and then take off the
pressure roller thermostat from its bracket by
releasing the harness out of the 2 terminals.
May 2006 © TOSHIBA TEC
Fig. 15-38
Clamp
Pressure roller thermostat bracket
Fig. 15-39
Harness
Fig. 15-40
e-STUDIO2500c/3500c/3510c FUSER UNIT / PAPER EXIT SECTION
15 - 27
Heat roller cover
Clamp
Clamp
Harness
Pressure roller
thermostat
15