Toshiba e-STUDIO2500c Service Manual page 185

(4) Remove 2 screws and take off the shutter
motor.
[E] Shutter status detection sensor (S20)
Note:
Perform step (2) only when the Damp Heater Kit (optional) is installed.
(1) Take off the shutter unit.
P.8-14 "[C] Shutter unit"
(2) Remove 2 screws, and then take off the
Damp Heater Kit (optional).
(3) Remove 1 clip, and then slide the actuator to
the rear side.
Note:
Be sure not to lose the removed pin.
May 2006 © TOSHIBA TEC
Shutter motor
Fig. 8-24
Fig. 8-25
Fig. 8-26
e-STUDIO2500c/3500c/3510c LASER OPTICAL UNIT
8 - 17
Damp heater
Actuator
Clip
Pin
8